Phonetics 2000 User Manual download pdf (Page 23)

Chapter 2: Installation

It is important to note that when the unit is turned off, all program-

ming is retained in non-volatile memory via the internal 3V lithium

battery. The “C” cell Ni-Cad batteries are not in use when the power

switch is off.

TELEPHONE LINE

Connect the CPP Monitor 2000’s PHONE LINE jack to a standard 2

wire analog phone line. The unit dials using pulse or tone, with loop

start only. The CPP Monitor 2000 will recognize ringer frequencies

from 16 to 60 Hz and will operate with all standard analog tele-

phone systems that accept pulse or tone dialing.

RS232 Port

Power Off/On

Voice

Record

Phone

Line

Phone

Ext.

Phone Line:

Attach standard

phone line here.

Phone Ext. is the

“Line Seize” jack

for use with other

phone devices.

To record messages, plug a

telephone directly into this jack.

DO NOT connect a Phone Line

to this jack.

RS232 for data communication

CPP Monitor 2000—Front View

CAUTION: Do NOT connect the unit’s VOICE

RECORD jack to a live telephone line as this will

cause permanent damage to the unit.

Certain private telephone systems and public switching equipment

may not accept the unit’s dialing or may generate an unacceptable

ring signal. In those cases, a dedicated line may be required for the

unit. Consult the supplier of your telephone system if you encounter

problems.

CAUTION: Never install telephone wiring during a

lightning storm. Never install telephone jacks in wet

locations unless the jack is specifically designed for

wet locations. Never touch uninsulated telephone

wires or terminals unless the telephone line has been

disconnected at the network interface. Use caution

when installing or modifying telephone lines.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 117 118

Comments to this Manuals

No comments

Phonetics 2000 User Manual Page 23

Comments to this Manuals