Phonetics 2000 User Manual download pdf (Page 87)

Chapter 6: Operation

data, which includes the current conditions of each input, power

status, and battery condition. If the Data Logger is enabled and

programmed to send with reports, a Data Log report will also be

sent at this time.

PART THREE: CALL-IN STATUS

Using PC with Manager 2000 Windows Software: At any time the

unit is idle (not dialing out or communicating locally), you can call

into it using a modem. CPP Monitor 2000 will answer after its

programmed “Rings To Answer,” connect, and go on-line. At this

point you have entered an on-line session identical to the local

programming session, and may program the unit as necessary.

Voice Mode:

You can also call into the CPP Monitor 2000 using a Touch-Tone

telephone. After answering, CPP Monitor 2000 will beep once.

Immediately press any key on your Touch-Tone keypad to get a

voice status report. If the CPP Monitor 2000 doesn’t receive a

Touch-Tone signal within a few seconds, it will attempt to make a

data (modem) connection. If a data connection isn’t made after the

programmed “Carrier Wait Time,” CPP Monitor 2000 will again

switch to voice mode and recite a status report. Immediately

following the status report, CPP Monitor 2000 prompts you for a

voice-mode password. This password allows you to use Touch-Tone

commands to both listen to and record the unit’s voice messages.

To listen to a recorded alarm message:

1. Press the [*] key on your phone.

2. Press the corresponding input number key: 1-8, or press 9 to

listen to the ID message.

CPP Monitor 2000 will recite the corresponding message.

To record a message remotely:

1. Press the # key on your phone.

2. For an input alarm message, press the corresponding input

number key: 1-8, or press 9 to record the ID message.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 117 118

No comments

Phonetics 2000 User Manual Page 87